Diagnostic Trouble Code (Dtc) 1716 - SSANGYONG Rexton Y200 Manual

5D2-38 TRANSFER CASE - TOD

DIAGNOSTIC TROUBLE CODE (DTC) 1716

TP Sensor Out of Range
Circuit Description
The transfer case control unit (TOD) receives throttle
position (TP) sensor signals from engine control module
(ECM) through CAN bus line.
Conditions for Setting the DTC
D The transfer case control unit (TOD) receives throttle
position (TP) sensor signal from engine control module
(ECM), but the signal is out of the range.
There is a bad communication between TOD and ECU.
•
TOD is malfunction.
•
ECU is malfunction.
Step
Was the TOD Diagnostic System Check performed?
1
1. Turn the ignition switch to OFF.
2. Connect the scan tool to data link connector (DLC)
and follow the directions given in the scan tool
2
manual.
3. Turn the ignition switch to ON and request engine
DTC.
Are there any engine DTC related throttle position (TP)
sensor?
1. Turn the ignition switch to OFF.
2. Disconnect the 18-pin connector from the transfer
case control unit (TOD).
3. Disconnect the gray connector from engine control
module (ECU).
4. Connect a digital ohmmeter between the following
TOD connector terminal and gray ECU connector
terminal.
•
B11 (TOD) and 38 (ECU)
3
•
B10 (TOD) and 37 (ECU)
•
B11 (TOD) and A24
•
B10 (TOD) and A23
•
B11 (TOD) and ground
•
B10 (TOD) and ground
Does the resistance of the all circuits measure within the
value specified?
Repair or replace any short wires, faulty connector, or
4
terminal.
Is the repair complete?
Action
Action taken When the DTC Sets
The TOD will illuminates 4WD CHECK indicator and
DTC is stored in TOD.
Diagnostic Aids
Check for poor connections of CAN bus line.
Check for ECU and TP sensor.
Test Description
The number(s) below refer to step(s) on the diagnostic
table.
2. This step decides the causal parts of the problem.
4. This step checks the ground condition.
6. This step checks the connection status.
Value
-
Go to Step 2
Go to specific
-
0 Ω
Go to Step 4
-
Yes No
Go to "TOD
Diagnostic
System
Check"
Go to "TOD
Diagnostic
System
Check"
engine DTC
diagnosis.
Go to Step 2
Go to Step 5
System OK -
SSANGYONG Y200