SSANGYONG Rexton Y200 Manual page 1274

SSANGYONG Y200
TRANSFER CASE - TOD 5D2-79
32. Remove the high-low range shift fork and collar
as an assembly.
33. Expand the tangs of the large snap ring in the
case.
34. With the input shaft against a bench, push the case
down and slide the main drive gear bearing
retainer off the bearing.
35. Lift the input shaft and front planet from the case.
36. If required, remove the oil seal from the case by
prying and pulling on the curved-up lip of the oil
seal.
Notice: Be careful not to damage the bearing,
YAD5D470
bearing cage or case.
37. Remove the internal snap ring from the planetary
carrier.
38. Separate the front planet from the input shaft.
39. Remove the external snap ring from the input shaft.
40. Place the input shaft in a vise and remove the
bearing.
41. Remove the thrust washer, thrust plate and the sun
gear off the input shaft.
YAD5D480
42. Inspect the bushing and needle bearing in the end
of the input shaft for wear or damage.
Notice: Under normal use, the needle bearing
and bushing should not require replacement. If
replacement is required, the bushing and needle
bearing must be replaced as a set.
YAD5D490