SSANGYONG Rexton Y200 Manual page 1282

SSANGYONG Y200
TRANSFER CASE - TOD 5D2-87
48. Install the bolts retaining the case halves and
tighten.
Installation Notice
Tightening Torque
YAD5D750
49. Install shift shaft oil seal if it is not installed.
YAD5D760
50. Using pliers equipped with soft jaws, rotate the
triangular shaft so it is aligned with the triangular
slot in the transfer case shift motor.
Notice: If triangular shaft will not rotate, rotate the
rear output shaft.
YAD5D770
51. Tighten manually the two nuts that attach the
slotted support bracket to the end of the motor
house.
52. Apply Black Non-Acid Cure Silicone Rubber or
equivalent to motor housing base and install on
transfer case.
53. Install the transfer case shift motor and three bolts
along with speed sensor wire harness bracket and
tighten.
Installation Notice
Tightening Torque
25 - 37 N•m
(8 - 27 lb-ft)
8 - 11 N•m
(71 - 97 lb-in)