Coding On Tod - SSANGYONG Rexton Y200 Manual

SSANGYONG Y200
TRANSFER CASE - TOD 5D2-25
Both Speed Sensor Faulty
If both the Front and Rear Speed Sensors are faulty
continuously for 0.5 seconds the "4WD CHECK" lamp
is illuminated. The TOD then responds as follows:
1. If the system is in High Range the TOD sets the
EMC Touch off level based on a vehicle speed of
0 and wheel slip control is suspended.
2. If the system is in Low Range, the EMC Duty Cycle
is set to maximum until the system is shifted out
of 4L.
3. All Electric Shift activity is halted until the Ignition
is cycled. If a shift is in progress it will be
completed.
If both Speed Sensors recover continuously for 0.5
second the TOD will function normally. The "4WD
CHECK" lamp is turned off but the fault code will remain
in memory.
EMC Test
The EMC is tested for open circuit or short circuit to
ground. If a fault is detected continuously for 0.8
second the "4WD CHECK" lamp is turned on and all
TODTM activity is halted.
If the EMC recovers continuously for 0.8 second the
TOD will function normally. The "4WD CHECK" lamp
is turned off but the fault code will remain in memory.

CODING ON TOD

Connection of Coding Tool
Construct SCANNER into diagnosis connector (20
pins) near fuse box in engine room as below figure.
1. Diagnosis Connector
2. SCANNER
Notice: Coding ; An input activity of data for the
proper performance by matching specification,
devices and system with control unit.
Coding required
1. Replacement of TOD control unit.
2. Adjustment by input error.
YAD5D150
3. Change of tire specification.
Coding method
1. Check and record engine type, axle ratio and tire
size.
2. Ignition "OFF".
3. Connect SCANNER with diagnosis connector in
engine room.
4. Ignition "ON".
5. Read the current memorized specification in TOD
control unit.