SSANGYONG Rexton Y200 Manual page 1252

Step
1. Connect terminal A1/A6 and terminal A9/A10 with
digital voltmeter.
2. Measure the voltage while switching the 4L/4H switch
from 4H to 4L.
4
Is the voltage within the specified value?
3. Connect terminal A2/A7 between terminals A9/A10
with digital voltmeter.
4. Measure the voltage while switching the 4L/4H switch
from 4L to 4H.
Is the voltage within specified range?
1. Disconnect 12-pin connector from transfer case control
unit (TOD) and black 7-pin connector.
2. Measure the resistance between following terminals.
•
A2 (TOD) and 6 (7-pin connector)
•
A7 (TOD) and 6 (7-pin connector)
5
•
A1 (TOD) and 7 (7-pin connector)
•
A6 (TOD) and 7 (7-pin connector)
Is the resistance equal to specified value?
3. Measure the voltage between following terminals:
•
A2/A7 (TOD) and ground
•
A1/A6 (TOD) and ground
Is the voltage below specified value?
Repair any open or short to battery circuit.
6
Is the repair complete?
1. Turn the ignition switch to OFF.
2. Disconnect the black 7-pin connector, for shift motor,
under the body.
7
.
3. Measure the resistance between terminal G and
terminal B.
Is the resistance within the specified value?
Replace the shift motor.
8
Is the repair complete?
Replace the TOD.
9
Is the repair complete?
SSANGYONG Y200
Action
TRANSFER CASE - TOD 5D2-57
Value Yes
11 ~ 14 V
11 ~ 14 V Go to Step 5
0 Ω
1 V Go to Step 7
- System OK
1 ~ 250 Ω
Go to Step 9
- System OK
- System OK
No
Go to Step 9
Go to Step 6
Go to Step 7
Go to Step 8
-
Go to Step 7