Table of Contents
Advertisement
Step
1. Check the fuse EF9, F10 and voltage supply circuit.
2. Repair or replace any open or damaged circuit or
4
fuse.
Is the repair complete?
Connect a digital ohmmeter between each of the
following TOD connector terminal and ground.
•
A9 (Ground)
5
•
A10 (Ground)
Does the resistance of the all circuits measure within the
value specified?
Repair or replace any open or damaged circuit.
6
Is the repair complete?
1. Disconnect the 7-pin connector under the body.
7
2. Measure the voltage between terminal 4 and ground.
Is the resistance within the value specified?
Repair open or short to battery circuit.
8
Is the repair complete?
Measure the resistance between the clutch coil terminal
9
H and ground.
Is the measurement within the value specified?
1. Replace EMC (Electronic Magnetic Clutch).
2. Connect all the connectors.
3. Connect a scan tool to the DLC.
10
4. Turn the ignition switch to ON.
5. Delete and request DTC.
Is the repair complete?
Replace TOD.
11
Is the repair complete?
SSANGYONG Y200
Action
TRANSFER CASE - TOD 5D2-41
Value
Yes
-
Go to Step 5
0 Ω
Go to Step 7
-
Go to Step 7
12
Go to Step 9
-
System OK
2.2 ~ 2.8 Ω
Go to Step 11
-
System OK
-
System OK
No
-
Go to Step 6
-
Go to Step 8
-
Go to Step 10
-
-
Advertisement
Chapters
Table of Contents
