Speed Sensor In Front And Rear Propeller Shaft 5D2-71 - SSANGYONG Rexton Y200 Manual

SSANGYONG Y200
5. Keep shift motor even then pull rearward.
6. Clean connection surface of transfer case and shift
motor.
7. If necessary, make a test by SCANNER with shift
motor assembly.
Notice: Do not disassemble shift motor. If
necessary, replace by shift motor assembly unit.
8. Applying sealant into connecting surface for new
shift motor.
9. Installation should follow the removal procedure
in the reverse order. Before installation, make sure
that motor position match with mode of 4H/4L
YAD5D320
switch.
Notice: When accord position of motor with 4H/
4L switch and transfer case match position of the
disconnected motor and new one.
SPEED SENSOR IN FRONT AND
REAR PROPELLER SHAFT
Replacement Procedure
1. Disconnect (-) cable from battery.
2. Detach shift motor assembly.
3. Disconnect front and rear speed sensor connector
(white 3 pin) upper backside transfer case.
4. Disconnect speed sensor connect from locking
sleeve by pushing.
5. Disconnect wire stick cap from the detached
connector.
6. Unscrew rear speed sensor mounting bolt (M10)
from upper side of rear case flange.
03E-019
YAD5D330
TRANSFER CASE - TOD 5D2-71