Changing The Login Password; Ssl Vpn Configuration Example In The Web Interface; Network Requirements - HP 6600 Security Configuration Manual

Changing the login password

To change the login password, a user needs to perform the following configurations:
1. Click the Configure button in the upper right corner of the SSL VPN service interface to enter the
page shown in
2. Enter the new password, and confirm the new password.
3. Click Apply.
When the user logs in again, the user must enter the new password.
Figure 196 Changing login password
SSL VPN configuration example in the Web
interface

Network requirements

As shown in
that users can use HTTPS to log in to the SSL VPN gateway to access the internal resources of the
corporate network.
In this configuration example:
In this example, the CA runs the Windows Server and the SCEP plugin is required on the CA.
•
• The IP address of the SSL VPN gateway is 10.1.1.1/24. The IP address of the CA is 10.2.1.1/24, and
the name of the CA is CA server. The CA is used to issue certificates to the SSL VPN gateway and
remote users.
Perform RADIUS authentication for SSL VPN users. The IP address of the RADIUS server (an IMC
•
server) is 10.153.10.131/24. After passing authentication, an SSL VPN user can access the internal
technology website whose IP address is 10.153.1.223, all hosts on subnet 10.153.2.0/24, and the
security sever whose IP address is 10.153.2.25 through the FTP shortcut.
Configure a public account named usera. Specify that only one user can use the public account to
•
log in at a time. Configure local authentication for the public account and authorize a user who logs
in by using the public account to access the shared desktop provided by internal host
10.153.70.120.
Figure 196.
Figure 197, request a certificate and enable SSL VPN service on the SSL VPN gateway so
419