Set The Physical State Change Suppression Interval On An E1 Interface; Restoring Default Settings For An E1 Voice Interface; Configuring Basic Parameters For A T1 Voice Interface; Configuring A Tdm Clock Source - HP FlexNetwork MSR Series Configuration Manual

Step
3. Create a TS set according to
the selected signaling mode.
4. Enter CAS view.
5. Configure an E1 trunk
routing mode.
Set the physical state change suppression interval on an E1
interface
Step
1. Enter system view.
2. Enter E1 interface view.
3. Set the physical state
change suppression interval
on the E1 interface.

Restoring default settings for an E1 voice interface

Step
1. Enter system view.
2. Enter E1 interface view.
3. Restore the default settings
on the E1 voice interface.
Configuring basic parameters for a T1 voice
interface
This section describes the basic parameters and procedures for configuring a T1 voice interface.

Configuring a TDM clock source

The TDM clock source configuration for a T1 interface is similar to that for an E1 interface. For more
information, see
To configure a TDM clock source:
Command
timeslot-set ts-set-number
timeslot-list timeslots-list signal
{ e&m-delay | e&m-immediate |
e&m-wink | fxo-ground |
fxo-loop | fxs-ground | fxs-loop
| r2 }
cas ts-set-number
select-mode { max | maxpoll |
min | minpoll }
Command
system-view
controller e1 slot-number
link-delay delay-time
Command
system-view
controller e1 slot-number
default
"Introduction to TDM clock source."
65
Remarks
By default, no TS set is
configured.
N/A
Optional.
By default, the timeslot with the
lowest number is selected from all
available timeslots for routing.
Remarks
N/A
N/A
Optional.
By default, the physical state
change suppression is disabled
on an E1 interface.
Remarks
N/A
N/A
Optional.