Bridge 1X1 Slot/Port Admin-Edge - Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual

Distributed Spanning Tree Commands

bridge 1x1 slot/port admin-edge

Configures the administrative edge port status for a port or an aggregate of ports for a 1x1 mode VLAN
instance.
bridge 1x1 vid {slot/port | logical_port} admin-edge {on | off | enable | disable}
Syntax Definitions
vid
slot/port
logical_port
on
off
enable
disable
Defaults
By default, the administrative edge port status is disabled (off).
Platforms Supported
OmniSwitch 6250
Usage Guidelines
•
This command is an explicit Spanning Tree command that only applies to the specified VLAN instance
regardless of which operating mode (flat or 1x1) is active on the switch.
•
If the switch is running in the flat mode when this command is used, the specified edge port status for
the port is not active for the VLAN instance until the switch is configured to run in the 1x1 Spanning
Tree mode.
•
Note that when a configuration snapshot is taken of the switch, all Spanning Tree commands are saved
in their explicit format.
•
The administrative edge port status is used to determine if a port is an edge or non-edge port when
automatic edge port configuration (auto-edge) is disabled for the port. However, if auto-edge is
enabled for the port, then the administrative status is overridden.
•
Rapid transition of a designated port to forwarding can only occur if the port's connection type is
defined as point to point or an edge port. Rapid transition of an alternate port role to a root port role is
not affected by the port connection type definition.
OmniSwitch 6250 CLI Reference Guide
An existing VLAN ID number (1–4094).
Enter the slot number for the module and the physical port number on
that module (e.g., 3/1 specifies port 1 on slot 3).
Link aggregate ID number (0–31).
Turns on the administrative edge port status for the specified
port-VLAN instance.
Turns off the administrative edge port status for the specified
port-VLAN instance.
Enables the administrative edge port status for the specified port-VLAN
instance.
Disables the administrative edge port status for the specified port-
VLAN instance.
November 2009 page 16-95