Interfaces Hybrid Duplex - Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual

interfaces hybrid duplex

Configures duplex mode on combo ports. In full duplex mode, the interface transmits and receives data
simultaneously. In half duplex mode, the interface can transmit or receive data at a given time. Auto
duplex setting causes the switch to advertise all available duplex modes (half/full/both) for the port during
autonegotiation.
interfaces slot[/port[-port2]] hybrid {fiber | copper} duplex {full | half | auto}
Syntax Definitions
slot
port
port2
fiber
copper
full
half
auto
Defaults
parameter
full | half | auto
Platforms Supported
OmniSwitch 6250
Usage Guidelines
The MIB table and MIB object listed in the "MIB Objects" section below apply to the inactive configured
media only. See the "MIB Objects" section in the
object for the active configured media.
Examples
-> interfaces 1/25 hybrid copper duplex auto
-> interfaces 1/25-26 hybrid copper duplex half
-> interfaces 1 hybrid copper fiber full
Release History
Release 6.6.1; command was introduced.
page 20-30
Slot number you want to configure.
Port number of the interface you want to configure.
Last port number in a range of ports you want to configure.
Specifies that configuration changes will be made to the SFP port(s).
Specifies that changes will be made to the copper RJ-45 port(s).
Sets interface to full duplex mode.
Sets interface to half duplex mode.
Switch will automatically set both the duplex mode settings to auto-
negotiation.
default
auto
interfaces duplex
OmniSwitch 6250 CLI Reference Guide
Ethernet Port Commands
section for the MIB table and MIB
November 2009