Show Interfaces Hybrid Flood Rate - Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual

show interfaces hybrid flood rate

Displays interface peak flood rate settings for combo ports.
show interfaces [slot[/port[-port2]]] hybrid {fiber |copper} flood rate
Syntax Definitions
slot
port
port2
fiber
copper
Defaults
If a specific slot or slot/port number is not entered with this command, the peak rate settings for all switch
combo ports is displayed.
Platforms Supported
OmniSwitch 6250
Usage Guidelines
•
Enter a slot and port number or a range of port numbers to display information for a specific combo
port or a range of combo ports.
•
Enter a slot number to display information for all combo ports on a specific slot.
Examples
-> show interfaces flood rate
Slot/Port peak rate(Mb/second)
-----------+----------------------+---------------
02/01
02/02
02/03
02/04
02/05
02/06
02/07
02/08
02/09
02/10
02/11
02/12
02/13
02/14
02/15
02/16
page 20-92
Slot number you want to display.
Port number of the interface you want to display.
Last port number in a range of ports you want to display.
Specifies that the status of the SFP port(s) will be displayed.
Specifies that the status of the copper RJ-45 port(s) will be displayed.
Enable
12 Flood only
47 Flood only
16 Flood only
47 Flood only
47 Flood only
47 Flood only
47 Flood only
47 Flood only
47 Flood only
47 Flood only
47 Flood only
47 Flood only
47 Flood only
47 Flood only
47 Flood only
47 Flood only
OmniSwitch 6250 CLI Reference Guide
Ethernet Port Commands
November 2009