Bridge Mst Region Revision Level - Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual

bridge mst region revision level

Defines the revision level for a Multiple Spanning Tree (MST) region. One of three attributes (name, revi-
sion level, and a VLAN to MST instance association table) that defines an MST region as required by the
IEEE 802.1Q 2005 standard. Switches that share the same attribute values are all considered part of the
same MST region. Currently each switch can belong to one MST region at a time.
bridge mst region revision level rev_level
Syntax Definitions
rev_level
Defaults
By default, the MST revision level is set to zero.
Platforms Supported
OmniSwitch 6250
Usage Guidelines
Specifying an MST region revision level is allowed regardless of which Spanning Tree operating mode or
protocol is currently active on the switch. However, MST configuration values, such as revision level, only
apply when the switch is operating in the flat Spanning Tree mode and using the MSTP.
Examples
-> bridge mst region revision level 1000
-> bridge mst region revision level 2000
Release History
Release 6.6.1; command was introduced.
Related Commands
bridge mst region name
bridge mst region max hops
bridge msti
bridge msti vlan
MIB Objects
vStpMstRegionTable
vStpMstRegionNumber
vStpMstRegionConfigRevisionLevel
page 16-14
A numeric value (0–65535) that identifies the MST region revision level
for the switch.
Defines the name for an MST region.
Defines the maximum number of hops for the MST region.
Defines a MSTI number that identifies an association between a range
of VLANs and a Spanning Tree instance.
Defines an association between a range of VLANs and a single MSTI.
OmniSwitch 6250 CLI Reference Guide
Distributed Spanning Tree Commands
November 2009