Mac-Range Eeprom - Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual

mac-range eeprom

Modifies the default MAC range on the switch's EEPROM.
Note. Use caution when modifying the default MAC range. Improper use of this command can disable
your system and adversely affect your network. Contact Alcatel-Lucent Customer Support for further
assistance.
mac-range eeprom start_mac_address count
Syntax Definitions
start_mac_address
count
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
•
Because the factory-installed 32 MAC addresses are sufficient for most network configurations, this
command should only be used by qualified network administrators for special network requirements.
•
After modifying a MAC address range by using the mac-range eeprom command, you must reboot
the switch. Otherwise, MAC addresses for existing VLAN router ports will not be allocated properly.
•
All MAC addresses in a range must be contiguous (i.e., there cannot be any gaps in the sequence of
MAC addresses).
Examples
-> mac-range eeprom 00:20:da:23:45:35 32
Release History
Release 6.1; command was introduced.
page 3-2
The first MAC address in the modified range. Enter the MAC address in
the following format: xx:xx:xx:xx:xx:xx, where x is a hex value (0–f).
Specifies the number of MAC addresses in the range (1–256).
OmniSwitch 6250 CLI Reference Guide
Chassis MAC Server (CMS) Commands
November 2009