Bridge 1X1 Protocol - Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual

bridge 1x1 protocol

Configures the Spanning Tree protocol for an individual VLAN instance.
bridge 1x1 vid protocol {stp | rstp}
Syntax Definitions
vid
stp
rstp
Defaults
RSTP is the default protocol for the flat mode CIST instance and for the 1x1 mode VLAN instance.
Platforms Supported
OmniSwitch 6250
Usage Guidelines
•
This command is an explicit Spanning Tree command that only applies to the specified VLAN instance
regardless of which operating mode (flat or 1x1) is active on the switch.
•
If the switch is running in flat mode when this command is used, the specified protocol is not active for
the specified VLAN instance until the operating mode for the switch is changed to 1x1.
•
Note that when a configuration snapshot is taken of the switch, all Spanning Tree commands are saved
in their explicit format.
Examples
-> bridge 1x1 2 protocol stp
-> bridge 1x1 455 protocol rstp
Release History
Release 6.6.1; command was introduced.
Related Commands
bridge mode
bridge protocol
bridge cist protocol
page 16-10
An existing VLAN ID number (1–4094).
IEEE 802.1D standard Spanning Tree Algorithm and Protocol.
IEEE 802.1w Rapid Spanning Tree Protocol.
Selects the Spanning Tree operating mode (flat or 1x1) for the switch.
Implicit command for changing the Spanning Tree protocol for the flat
mode instance or for a 1x1 mode VLAN instance.
Explicit command for changing the Spanning Tree protocol for the flat
mode instance.
OmniSwitch 6250 CLI Reference Guide
Distributed Spanning Tree Commands
November 2009