802.1Q Commands; Vlan 802.1Q - Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual

vlan 802.1q

Creates, deletes, or modifies 802.1Q tagging on a single port or on an aggregate of ports.
vlan vid 802.1q {slot/port | aggregate_id} [description]
vlan vid no 802.1q {slot/port | aggregate_id}
Syntax Definitions
vid
slot
port
aggregate_id
description
Defaults
The default description for 802.1Q tagging on a port is TAG PORT slot/port VLAN vid (where the slot/
port and vid are as entered when inputting the command) when you configure 802.1Q tagging on a single
port, and TAG AGGREGATE aggregate_id VLAN vid (where the slot/port and vid are as entered when
inputting the command) when you configure 802.1q tagging on an aggregate link.
Platforms Supported
OmniSwitch 6250
Usage Guidelines
•
Use the no form of this command to delete 802.1Q tagging on a port or an aggregate of ports.
•
The VLAN specified for the port or aggregate link before 802.1Q tagging can be specified. See
Chapter 22, "VLAN Management Commands"
•
You must enable link aggregation before you can tag an aggregate of ports. See
Aggregation Commands"
•
The port's default VLAN can never be configured to accepted tagged frames.
Examples
-> vlan 2 802.1q 3/1
-> vlan 10 802.1q 100
-> vlan 5 802.1q 4/2 "802.1q tag 2"
-> vlan 6 no 802.1q 3/1
page 15-2
The VLAN identification number for a preconfigured VLAN that will
handle the 802.1Q traffic for this port. The valid range is 1 to 4094.
The slot number for the 802.1Q tagging.
The port number for the 802.1Q tagging.
The link aggregation ID, which allows you to configure 802.1Q tagging
on an aggregate of ports. The valid range is 1 to 31.
An optional textual description (up to 32 characters) for this 802.1Q tag.
Spaces must be unclosed within quotation marks (e.g., "802.1Q tag 2").
for information on how to create a VLAN.
for more information on link aggregation.
OmniSwitch 6250 CLI Reference Guide

802.1Q Commands

Chapter 12, "Link
November 2009