Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual page 996

1/4
1/5
-> show efm-oam port 1/1-3 enabled
Port Mode
-------+----------------+---------+-------------------+----------------
1/1 active
1/3 passive
-> show efm-oam port enabled
Port Mode
---------+--------+-------------------+----------------
1/1 active
1/3 passive
1/7 passive
-> show efm-oam port disabled
Port Mode
---------+--------+-------------------+----------------
1/2 active
1/4 passive
1/5 active
-> show efm-oam port enabled passive
Port Operational Status
---------+--------+-------------------+----------------
1/3 activeSendLocal
1/7 activeSendLocal
-> show efm-oam port active
Port EFM-OAM Status
-------+----------------+---------------------+-------+----------------
1/1 enabled
1/2 disabled
1/3 enabled
1/4 disabled
1/5 disabled
1/6 disabled
1/7 disabled
Output fields are described here:
output definitions
Port
EFM-OAM Status
page 26-28
disabled active
disabled active
Operational Status
operational
activeSendLocal
Operational Status
activeSendLocal
activeSendLocal
activeSendLocal
Operational Status
activeSendLocal
activeSendLocal
activeSendLocal
Loopback Status
noLoopback
noLoopback
Operational Status
activeSendLocal
activeSendLocal
activeSendLocal
activeSendLocal
activeSendLocal
activeSendLocal
activeSendLocal
Displays the slot/port number.
The state of the EFM-OAM. LINK OAM instance can have any of the
following status.
•
Enabled : Specifies that the LINK OAM is disabled on the
interface.
•
Disabled : Specifies that the LINK OAM is disabled on the
interface.
activeSendLocal
activeSendLocal
Loopback Status
remoteLoopback
noLoopback
Loopback Status
remoteLoopback
noLoopback
noLoopback
Loopback Status
noLoopback
noLoopback
noLoopback
Loopback Status
remoteLoopback
noLoopback
noLoopback
noLoopback
noLoopback
noLoopback
noLoopback
OmniSwitch 6250 CLI Reference Guide
LINK OAM Commands
noLoopback
noLoopback
November 2009