Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual page 940

Hide thumbs Also See for OmniSwitch 6250:

Table of Contents

Usage Guidelines

This command allows an operator to generate a loopback message for the specified MEP.

This command signals the MEP that it should transmit loopback messages and detect the presence or

lack of the corresponding loopback reply(s).

Note that a loopback message is used for fault verification.

This command is used to validate the connectivity between Maintenance End Points (MEP) and Main-

tenance Intermediate Points (MIP).

-> ethoam loopback target-macaddress 10:aa:ac:12:12:ad source-endpoint 4 domain

esd.alcatel-lucent.com association alcatel-sales number 10 vlan-priority 4

drop-eligible true

-> ethoam loopback target-endpoint 15 source-endpoint 4 domain esd.alcatel-

lucent.com association alcatel-sales

Release History

Release 6.6.1; command was introduced.

Related Commands

show ethoam domain

Dot1agCfmMepTransmitLbm

dot1agCfmMepTransmitLbmDestMacAddress

dot1agCfmMepTransmitLbmDestMepId

dot1agCfmMepTransmitLbmDestlsMepId

dot1agCfmMepTransmitLbmMessages

dot1agCfmMepTransmitLbmDataTlv

dot1agCfmMepTransmitLbmVlanPriority

dot1agCfmMepTransmitLbmVlanDropEnable

dot1agCfmMepTransmitLbmResultOK

Displays the information of a specified Management Domain con-

figured on the bridge.

OmniSwitch 6250 CLI Reference Guide

Ethernet OAM Commands

November 2009