Configuration File Manager Commands
show configuration snapshot
Displays the switch's current running configuration for all features or for the specified feature(s).
show configuration snapshot [feature_list]
Syntax Definitions
feature_list
snapshot-supported features
802.1q
aaa
aip
all
bridge
chassis
efm-oam
ethernet-oam
health
interface
ip
Defaults
By default, this command shows configuration information for all features.
Platforms Supported
OmniSwitch 6250
Usage Guidelines
•
Use this command to view the current configuration for any feature shown in the table.
•
To show a list of features on the switch, use the show configuration snapshot ? syntax.
•
Configurations are listed below the name of each feature.
•
Features with no current configuration show only the name of the feature.
OmniSwitch 6250 CLI Reference Guide
Specify the feature(s) for which you want to display the running config-
uration. List the features separated by a space with no comma.
ip-helper
ip-routing
ipmr
ipms
ipv6
linkagg
loopback-detection
module
ntp
port-mapping
pmm
November 2009
policy
qos
rdp
rip
ripng
session
snmp
stack-manager
stp
vlan
page 9-13