Show Spantree Mst Port - Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual

show spantree mst port

Displays a summary of Spanning Tree connection information and instance associations for the specified
port or a link aggregate of ports.
show spantree mst port {slot/port | logical_port}
Syntax Definitions
slot/port
logical_port
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
•
This command is only available when the switch is running in the flat Spanning Tree mode.
•
Note that MST 0 also represents the flat mode CIST instance, which all ports are associated with when
the switch is running in the flat Spanning Tree mode.
Examples
-> bridge mode flat
-> show spantree mst port 1/10
MST parameters for interface 1/10:
Conection Type:
Edge Port: YES
Boundary Port: YES
MST | Role | State | Pth Cst | Vlans
--------------------------------------------------------
0 DIS
2 DIS
-> show spantree mst port 1/1
MST parameters for interface 1/1 :
Conection Type: PTP
Edge Port: NO
Boundary Port: YES
MST | Role | State | Pth Cst | Vlans
--------------------------------------------------------
0 ROOT
-> bridge mode 1x1
-> show spantree mst port 1/10
Current STP mode is 1x1, MSTI instances are inactive
page 16-168
The slot number for the module and the physical port number on that
module (e.g., 3/1 specifies port 1 on slot 3).
The Link aggregate ID number (0–31).
NS
DIS 0 200
DIS 0
FORW 19 1
Distributed Spanning Tree Commands
OmniSwitch 6250 CLI Reference Guide November 2009