Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual page 631

Source Learning Commands
•
Select the filtering parameter to set up a denial of service to block potential hostile attacks. Traffic sent
to or from a filtered MAC address is dropped. Select the bridging parameter for regular traffic flow to
or from the MAC address.
•
If a packet received on a port associated with the same VLAN contains a source address that matches a
static MAC address, the packet is discarded.
•
Static MACs are not supported on mobile ports.
•
Only static MAC address entries with a permanent management status are captured when a snapshot
of the switch's running configuration is taken.
•
Use the mac-address-table aging-time command (see
static and dynamically learned MAC addresses. This is the value applied to static MAC addresses
defined using the mac-address-table timeout form of this command.
Examples
-> mac-address-table permanent 00:00:39:59:f1:0c 4/2 355
-> no mac-address-table
-> no mac-address-table 5/1 755
-> no mac-address-table permanent
Release History
Release 6.6.1; command was introduced.
Related Commands
mac-address-table aging-time
show mac-address-table
show mac-address-table count
show mac-address-table aging-
time
MIB Objects
slMacAddressTable
slMacAddress
slMacAddressManagement
slMacAddressDisposition
OmniSwitch 6250 CLI Reference Guide
page
Configures aging time, in seconds, for static and dynamically learned
MAC addresses.
Displays Source Learning MAC Address Table information.
Displays Source Learning MAC Address Table statistics.
Displays the current aging time value for the Source Learning MAC
Address Table.
November 2009
18-6) to set the aging time value for all
page 18-3