Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual page 433

15 802.1Q Commands
Alcatel-Lucent's 802.1Q is an IEEE standard for sending frames through the network tagged with VLAN
identification. This chapter details configuring and monitoring 802.1Q tagging on a single port in a switch
or an aggregate of ports on a switch.
Alcatel-Lucent's version of 802.1Q complies with the Draft Standard P802.1Q/D11 IEEE Standards for
Local And Metropolitan Area Network: Virtual Bridged Local Area Networks, July 30, 1998.
MIB information for the 802.1Q commands is as follows:
Filename: alcatelIND1Dot1Q.mib
Module: ALCATEL-IND1-DOT1Q-MIB
A summary of available commands is listed here:
vlan 802.1q
vlan 802.1q frame type
show 802.1q
Note. Before using 802.1Q, the VLAN for 802.1Q must be created using the commands described in
Chapter 22, "VLAN Management Commands."
Configuration procedures for 802.1Q are explained in "Configuring 802.1Q," OmniSwitch 6250 Network
Configuration Guide.
OmniSwitch 6250 CLI Reference Guide November 2009 page 15-1