Configuration Error-File Limit - Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual

configuration error-file limit

Specifies the maximum number of configuration error files allowed in the switch's /flash directory. Error
files are normally generated when a configuration file is applied to the switch. Error files are identified by
their .err extension.When the maximum number of .err files is exceeded, any new error file will over-
write the .err file with the oldest timestamp.
configuration error-file limit number
Syntax Definitions
number
Defaults
parameter
number
Platforms Supported
OmniSwitch 6250
Usage Guidelines
•
When the error file limit is set to 1 (the default value), the next error file generated by the switch will
replace the existing one.
•
When the error file limit is set to a value greater than 1, when a new error file that exceeds the
maximum limit is created, the switch will automatically remove the error file with the smallest times-
tamp.
•
The error files generated by the switch have the .err extension.
•
If you want to save an error file, you may change the file name so that it does not have the .err
extension, or you can move it from the /flash directory.
Examples
-> configuration error-file limit 2
-> configuration error-file limit 1
Release History
Release 6.6.1; command was introduced.
page 9-4
Indicate the number of error files allowed in the /flash directory. The
valid range is from 1 to 25 files.
default
1
OmniSwitch 6250 CLI Reference Guide
Configuration File Manager Commands
November 2009