Link Aggregation Commands
lacp linkagg partner system id
Configures the MAC address of the remote system's dynamic aggregate group to which the local switch's
dynamic aggregate group is attached.
lacp linkagg agg_num partner system id partner_system_id
lacp linkagg agg_num no partner system id
Syntax Definitions
agg_num
partner_system_id
Defaults
parameter
partner_system_id
Platforms Supported
OmniSwitch 6250
Usage Guidelines
•
Use the no form of this command to remove a partner system ID from a dynamic aggregate group.
•
The partner_system_id and the partner_system_priority specify the remote system's priority.
Examples
-> lacp linkagg 2 partner system id 00:20:da4:32:81
-> lacp linkagg 2 no partner system id
Release History
Release 6.6.1; command was introduced.
OmniSwitch 6250 CLI Reference Guide
The number corresponding to the dynamic aggregate group on the
switch.
The MAC address of the remote switch's dynamic aggregate group in
the hexadecimal format xx:xx:xx:xx:xx:xx.
default
0
November 2009
page 12-17