Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual page 565

Distributed Spanning Tree Commands
output definitions (continued)
Forward Delay
Hello Time
System Max Age
System Forward Delay
System Forward Delay
Release History
Release 6.6.1; command was introduced.
Related Commands
show spantree
show spantree msti
show spantree 1x1
OmniSwitch 6250 CLI Reference Guide
The amount of time (in seconds) that a port will remain in the Listening
state and then the Learning state until it reaches the forwarding state.
This is also the amount of time used to age out all dynamic entries in
the Forwarding Database when a topology change occurs. Configured
through the bridge forward delay
The amount of time (in seconds) between the transmission of Configu-
ration BPDUs on any port that is the Spanning Tree root or is attempt-
ing to become the Spanning Tree root. Configured through the
hello time command.
The Max Age value for the root bridge.
The Forward Delay value for the root bridge.
The Forward Delay value for the root bridge.
Implicit command for displaying the Spanning Tree bridge configu-
ration for the flat mode CIST instance or a 1x1 mode VLAN
instance.
Explicit command for displaying the Spanning Tree bridge configu-
ration for an MSTI regardless of which mode (1x1 or flat) is active
on the switch.
Explicit command for displaying the Spanning Tree bridge configu-
ration for a VLAN instance regardless of which mode (1x1 or flat)
is active on the switch.
November 2009
command.
page 16-125
bridge