Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual page 528

•
Rapid transition of a designated port to forwarding can only occur if the port's connection type is
defined as a point to point or an edge port. Rapid transition of an alternate port role to a root port role is
not affected by the port connection type definition.
Examples
-> bridge mode flat
-> bridge 1 1/24 connection noptp
-> bridge mode 1x1
-> bridge 200 8/2 connection ptp
-> bridge 300 10 connection autoptp
Release History
Release 6.6.1; command was introduced.
Related Commands
bridge mode
bridge cist slot/port connection
bridge 1x1 slot/port connection
bridge cist slot/port admin-edge
bridge cist slot/port auto-edge
MIB Objects
vStpInsPortTable
vStpInsPortNumber
vStpInsPortAdminConnectionType
vStpInsPortOperConnectionType
page 16-88
Selects the Spanning Tree operating mode (flat or 1x1) for the switch.
Explicit command for configuring the Spanning Tree connection type
for a port or an aggregate of ports for the CIST instance when the
switch is operating in either the 1x1 or flat Spanning Tree mode.
Explicit command for configuring the Spanning Tree connection type
for a port or an aggregate of ports for the specified VLAN instance
when the switch is operating in either the 1x1 or flat Spanning Tree
mode.
Configures the administrative edge port status for a port or aggregate
of ports for the CIST instance.
Configures whether or not Spanning Tree automatically determines the
operational edge status of a port or an aggregate of ports for the flat
mode CIST instance.
OmniSwitch 6250 CLI Reference Guide
Distributed Spanning Tree Commands
November 2009