Lldp Notification - Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual

802.1AB Commands

lldp notification

Specifies the switch to control per port notification status about the remote device change.
lldp {slot/port | slot | chassis} notification {enable | disable}
Syntax Definitions
slot/port
slot
enable
disable
Defaults
parameter
enable | disable
Platforms Supported
OmniSwitch 6250
Usage Guidelines
•
The LLDPDU administrative status must be in the receive state before using this command.
•
If this command is applied to a slot or chassis, then the existing configuration related to this command
will be lost.
Examples
-> lldp 1/2 notification enable
-> lldp 1 notification disable
Release History
Release 6.6.1; command was introduced.
OmniSwitch 6250 CLI Reference Guide
Slot number for the module and physical port number on that module
(e.g., 3/1 specifies port 1 on slot 3).
The slot number for a specific module.
Enables the notification of local system MIB changes.
Disables the notification.
default
disable
November 2009 page 13-9