Efm-Oam Port Hello-Interval - Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual

LINK OAM Commands

efm-oam port hello-interval

Configures the time interval (in seconds) by which the information OAMPDUs are transmitted out of an
LINK OAM enabled port.
efm-oam port slot/port[-port2] hello-interval seconds
Syntax Definitions
slot/port
-port2
seconds
Defaults
By default, the hello-interval value is set to 1 second.
Platforms Supported
OmniSwitch 6250.
Usage Guidelines
•
Use the hello-interval value of 1 second to reset the timer to its default value.
•
On a given port, hello interval time period should not be more than half of keep alive timer on the peer
port.
Examples
-> efm-oam port 1/1 hello-interval 5
-> efm-oam port 2/1-10 hello-interval 10
Release History
Release 6.6.1; command was introduced.
OmniSwitch 6250 CLI Reference Guide
The slot number for the module and the physical port number on that
module (e.g. 3/1 specifies port 1 on slot 3).
Specifies the last port in the range of ports.
Specifies the time interval (in seconds) this port waits before sending
out the next hello packet.The range for this timer is 1 to 60 seconds.
November 2009 page 26-9