show interfaces hybrid counters errors
Displays interface error frame information (e.g., CRC errors, transit errors, receive errors) for combo
ports.
show interfaces [slot[/port[-port2]]] hybrid {fiber |copper} counters errors
Syntax Definitions
slot
port
port2
fiber
copper
Defaults
If a specific slot or slot/port number is not entered with this command, the error frame information for all
switch combo ports is displayed.
Platforms Supported
OmniSwitch 6250
Usage Guidelines
•
Enter a slot and port number or a range of port numbers to display information for a specific combo
port or a range of combo ports.
•
Enter a slot number to display information for all combo ports on a specific slot.
•
These counters do not apply to Gigabit Ethernet traffic.
Examples
-> show interfaces 1/25 hybrid copper counters errors
01/25,
Alignments Errors = 6.45E13,
IfInErrors
Undersize pkts
output definitions
Slot/Port
Alignments Errors
FCS Errors
IfInErrors
page 20-84
Slot number you want to display.
Port number of the interface you want to display.
Last port number in a range of ports you want to display.
Specifies that statistics for the SFP port(s) will be displayed.
Specifies that statistics for the copper RJ-45 port(s) will be displayed.
FCS Errors = 7.65E12
= 6435346,
IfOutErrors= 5543,
= 867568, Oversize pkts = 5.98E8
Interface slot and port number.
Number of Alignments errors.
Number of Frame Check Sequence errors.
Number of received error frames.
OmniSwitch 6250 CLI Reference Guide
Ethernet Port Commands
November 2009