Lldp Tlv Management - Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual

802.1AB Commands

lldp tlv management

Specifies the switch to control per port management TLVs to be incorporated in the LLDPDUs.
lldp {slot/port | slot | chassis} tlv management {port-description | system-name | system-description |
system-capabilities | management-address} {enable | disable}
Syntax Definitions
slot/port
slot
port-description
system-name
system-description
system-capabilities
management-address
enable
disable
Defaults
parameter
enable | disable
Platforms Supported
OmniSwitch 6250
Usage Guidelines
•
The LLDPDU must be enabled and set to transmit before using this command.
•
If this command is applied to a slot or chassis, then the existing configuration related to this command
will be lost.
Examples
-> lldp 1/2 tlv management port-description enable
-> lldp 2 tlv management management-address enable
-> lldp 3 tlv management system-name disable
OmniSwitch 6250 CLI Reference Guide
Slot number for the module and physical port number on that module
(e.g., 3/1 specifies port 1 on slot 3).
The slot number for a specific module.
Enables or disables the transmission of port description TLV in
LLDPDU.
Enables or disables the transmission of system name TLV in LLDPDU.
Enables or disables transmission of system description TLV in
LLDPDU.
Enables or disables transmission of system capabilities TLV in
LLDPDU.
Enables or disables transmission of management address on per port.
Enables management TLV LLDPDU transmission.
Disables management TLV LLDPDU transmission.
default
disable
November 2009 page 13-11