Trap Port Link - Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual

Ethernet Port Commands

trap port link

Enables trap link messages. If enabled, a message is displayed on the Network Management Station
(NMS) whenever the port changes state.
trap slot[/port[-port2]] port link {enable | disable | on | off}
Syntax Definitions
slot
port
port2
enable
disable
on
off
Defaults
parameter
enable | disable | on | off
Platforms Supported
OmniSwitch 6250
Usage Guidelines
N/A
Examples
-> trap 3/1 port link enable
-> trap 3 port link enable
-> trap 3/1-6 port link enable
Release History
Release 6.6.1; command was introduced.
OmniSwitch 6250 CLI Reference Guide
Slot number you want to configure.
Port number of the interface you want to configure.
Last port number in a range of ports you want to configure.
Port link up/down traps are displayed on the NMS.
Port link up/down traps are not displayed on the NMS.
Same as enable.
Same as disable.
default
disable
November 2009 page 20-3