Show Vlan - Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual

show vlan

Displays a list of VLANs configured on the switch.
show vlan [vid]
Syntax Definitions
vid
Defaults
By default, a list of all VLANs is displayed.
Platforms Supported
OmniSwitch 6250
Usage Guidelines
•
Specify a VLAN ID with this command to display information about a specific VLAN.
•
Note that specifying a range of VLAN IDs is also allowed. Use a hyphen to indicate a contiguous range
(e.g., show vlan 10-15). Note that only one VLAN entry—a single VLAN ID or a range of VLAN
IDs— is allowed with this command. Multiple entries are not accepted.
Examples
-> show vlan
vlan type admin
-----+-----+------+-----+----+-----+----+-----+ ----+-----+---------
1 std on
100 vstk on
-> show vlan 1
Name
Administrative State: enabled,
Operational State
1x1 Spanning Tree State : enabled,
Flat Spanning Tree State : enabled,
IP Router Port
Mobile Tag
Source Learning
-> show vlan 100
Name
Administrative State: enabled,
Operational State
1x1 Spanning Tree State : disabled,
Flat Spanning Tree State : enabled,
IP Router Port
IP MTU
page 22-12
VLAN ID number (1–4094).
stree
oper 1x1 flat auth
on on on off
off off on off
: VLAN 1,
: enabled,
: off,
: off,
: enabled
: VLAN 100,
: disabled,
: off,
: 1500,
mble src
ip tag lrn
off off on
off off off
OmniSwitch 6250 CLI Reference Guide
VLAN Management Commands
name
VLAN 1
VLAN 100
November 2009