vlan ip
Defines an IP network address rule for an existing VLAN. If a device sends traffic that matches the IP
address specified in the rule, the device and its mobile port will join the rule's VLAN.
vlan vid ip ip_address [subnet_mask]
vlan vid no ip ip_address [subnet_mask]
Syntax Definitions
vid
ip_address
subnet_mask
Defaults
By default, the subnet mask is set to the default subnet mask value for the IP address class.
Platforms Supported
OmniSwitch 6250
Usage Guidelines
•
Use the no form of this command to delete an IP network address rule from the specified VLAN.
•
Network address rules take precedence behind DHCP, binding, and MAC address rules.
•
Use DHCP rules in combination with IP network address rules to capture and forward DHCP traffic.
•
Rules are only assigned to existing VLANs. Use the vlan command to create a new VLAN.
Examples
-> vlan 10 ip 51.0.0.0 255.0.0.0
-> vlan 20 ip 21.0.0.0
-> vlan 10 no ip 21.0.0.0 255.0.0.0
-> vlan 10 no ip 51.0.0.0
Release History
Release 6.6.1; command was introduced.
page 21-14
VLAN ID number (1–4094).
IP network address (e.g., 10.0.0.0, 171.15.0.0, 196.190.254.0)
Class A, B, or C subnet mask (e.g., 255.0.0.0, 255.255.0.0, or
255.255.255.0).
OmniSwitch 6250 CLI Reference Guide
Port Mobility Commands
November 2009