Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual page 560

-> bridge mode 1x1
-> show spantree
Spanning Tree Path Cost Mode : AUTO
Spanning Tree PVST+ Mode
Vlan STP Status Protocol Priority
-----+----------+--------+--------------
1 ON
2 ON
3 ON
4 ON
5 ON
6 ON
7 ON
-> show spantree 2
Spanning Tree Parameters for Vlan 2
Spanning Tree Status :
Protocol
mode
Priority
Bridge ID
Designated Root
Cost to Root Bridge
Root Port
Next Best Root Cost
Next Best Root Port
Tx Hold Count
Topology Changes
Topology age
Current Parameters (seconds)
Max Age
Forward Delay
Hello Time
Parameters system uses when attempting to become root
System Max Age
System Forward Delay =
System Hello Time
output definitions
Spanning Tree Path Cost
Mode
Spanning Tree PVST+ Mode
Vlan
STP Status
Protocol
Mode
page 16-120
: Enable
STP 32768 (0x8000)
STP 32768 (0x8000)
STP 32768 (0x8000)
STP 32768 (0x8000)
STP 32768 (0x8000)
STP 32768 (0x8000)
STP 32768 (0x8000)
: IEEE STP,
: PVST+ (1 STP per Vlan),
: 32768 (0x8000),
: 8000-00:d0:95:6a:f4:58,
: 0000-00:00:00:00:00:00,
:
: Slot 1 Interface 1,
:
: Slot 1 Interface 1,
:
:
: 00:00:00,
= 20,
= 15,
= 2
= 20,
15,
= 2
The Spanning Tree path cost mode for the switch (32 BIT or AUTO)
Configured through the
Indicates whether the PVST + status is enabled or disabled. Configured
through the bridge mode 1x1 pvst+
The VLAN ID associated with the VLAN Spanning Tree instance.
Configured through the
The Spanning Tree state for the instance (ON or OFF). Configured
through the vlan stp
The Spanning Tree protocol applied to this instance (STP or RSTP).
Configured through the
The Spanning Tree operating mode for the switch (PVST+, 1x1 or
flat). Configured through
command.
OmniSwitch 6250 CLI Reference Guide
Distributed Spanning Tree Commands
ON,
0,
0,
6,
0,
bridge path cost mode
command.
vlan commands
command.
bridge protocol command.
bridge mode 1x1 pvst+
command.
or bridge mode
November 2009