Stack Clear Slot - Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual

Hide thumbs Also See for OmniSwitch 6250:

Table of Contents

stack clear slot

Clears the current saved slot information for a switch within a stacked configuration. When the saved slot

information has been cleared via the stack clear slot command, the corresponding switch will automati-

cally be assigned a unique slot number following a reboot. The command also provides optional syntax for

immediately forcing the corresponding switch into pass-though mode.

stack clear slot slot-number [immediate]

Syntax Definitions

Platforms Supported

OmniSwitch 6250

Usage Guidelines

When the stack clear slot command is issued, the boot.slot.cfg file is immediately removed from the

switch's /flash directory. As a result, no slot assignment information will be found the next time the

switch is booted. Because the switch's slot will be considered undefined during the boot process, the

switch is automatically assigned a unique slot number.

Primary and secondary management modules cannot be forced into pass-through mode using the

stack clear slot command. If the user attempts to force the secondary management module into pass-

through, the secondary switch will reboot and assume idle status when it comes back up. Meanwhile,

an idle switch within the stack is selected and rebooted; when it comes up it assumes the secondary

-> stack clear slot 1002

-> stack clear slot 3 immediate

Release History

Release 6.6.1; command was introduced.

The current slot position used by the switch (1–8; 1001–1008). Note that

the valid slot number range also includes slot positions 1001 through

1008, reserved for switches in pass-through mode.

Optional command syntax. When immediate is entered in the command

line, the corresponding switch is essentially manually forced into pass-

through mode at the time the command is entered. All traffic on the

switch's Ethernet ports is stopped. Unprocessed traffic (if applicable)

will continue to be passed through the stacking cables to other switches

in the stack. A limited number of management commands on the switch

are also supported.

OmniSwitch 6250 CLI Reference Guide

Chassis Management and Monitoring Commands

November 2009