Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual page 586

-> show spantree cist ports active
Spanning Tree Port Summary for Cist
Oper Path
Port St Cost
-----+----+-------+-------+----+----+----+----+----------------------
1/1 FORW 200000
output definitions
Port
Oper St
Path Cost
Desig Cost
Role
Prim. Port
Op Cnx
Op Edg
Desig Bridge ID
-> show spantree cist ports configured
Spanning Tree Port Admin Configuration for Vlan 1
Port Adm
Port Pri St.
-----+----+----+-----+-------+----+----+----+----+-----------+--------+--------
1/1 7 ENA
1/2 7 ENA
1/3 7 ENA
1/4 7 ENA
page 16-146
Desig Prim. Op
Cost Role Port
52 ROOT 1/1
The slot number for the module and the physical port number or a logi-
cal port. If the slot number is 0, then the port number refers to a link
aggregate logical port number (e.g., 0/31).
The port operational state as defined by application of the Spanning
Tree Protocol. Possible port operational states include: disabled, block-
ing, listening, learning, and forwarding.
The contribution of this port to the path cost towards the Spanning Tree
root bridge that includes this port. Path cost is a measure of the distance
of the listed port from the root bridge in the number of hops. Config-
ured through the
The path cost of the Designated Port of the segment connected to this
port. If this is the root bridge or the Spanning Tree status of the port is
administratively disabled, this value is 0.
The role of the port for this Spanning Tree instance. Possible port roles
are: root, designated, alternate, and backup.
The slot number for the module and the physical port number on that
module for the primary port associated with this Spanning Tree
instance. This information is only available if the port role is backup.
Operational connection type: PTP, NPT, or NS (nonsignificant).
Shows the current operational state of the port's connection type. See
the bridge slot/port connection
information.
Operational connection type: EDG. Shows the current operational state
of the port's connection type. See the
command on
The bridge identifier for the designated bridge for this port's segment.
Man. Config Adm Adm
Mode Cost Cnx Edg
No 0 AUT No
No 0 AUT No
No 0 AUT No
No 0 AUT No
Distributed Spanning Tree Commands
Op
Cnx Edg Desig Bridge ID
PTP EDG 8000-00:30:f1:5b:37:73
bridge slot/port path cost
command on
page 16-87 for more information.
Aut Rstr Rstr Role/ OS8800
Edg Tcn Root Guard 10G Opt
Yes No No
Yes No No
Yes No No
Yes No No
OmniSwitch 6250 CLI Reference Guide
command.
page 16-87 for more
bridge slot/port connection
PVST+
Cfg Stat
DIS AUT Off
DIS AUT Off
DIS AUT Off
DIS AUT Off
November 2009