Ntp Server; Chapter 5 Network Time Protocol Commands - Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual

ntp server

Specifies an NTP server from which the switch will receive updates.
ntp server {ip_address | domain_name} [key key | version version | minpoll exponent | prefer]
no ntp server {ip_address | domain_name}
Syntax Definitions
ip_address
domain_name
key
version
exponent
prefer
Defaults
Parameter
version
exponent
prefer
Platforms Supported
OmniSwitch 6250
Usage Guidelines
•
Use the no form of this command to delete the specified server.
•
To configure NTP in the client mode you must first define the NTP servers. Up to 3 NTP servers may
be defined.
•
Either an IP address or domain name for the specified server can be entered.
•
The NTP key identification is an integer. It corresponds to an MD5 authentication key contained in an
authentication file (.txt) located on the server. This file must be on both the server and the local switch,
and match, for authentication to work. Enter the key identification using the key keyword if the server
is set to MD5 authentication.
page 5-2
The IP address of the NTP server to be added or deleted to the client's
server list.
The domain name of the NTP server to be added or deleted to the
client's server list. This is usually a text string.
The key identification number that corresponds to the specified NTP
server.
The version of NTP being used. This will be 1, 2, 3, or 4.
The number of seconds between polls to this server. This number is
determined by raising 2 to the power of the number entered. Therefore,
if 4 were entered, the minimum poll time would be 16 seconds (2
16).
Marks this server as the preferred server. A preferred server's times-
tamp will be used before another server.
Default
4
6
not preferred
OmniSwitch 6250 CLI Reference Guide
Network Time Protocol Commands
November 2009
4
=