Interfaces Speed - Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual

Ethernet Port Commands

interfaces speed

Configures interface line speed.
interfaces slot[/port[-port2]] speed {auto | 10 | 100 | 1000 | 10000 | max {100 | 1000}}
Syntax Definitions
slot
port
port2
auto
10
100
1000
10000
max 100
max 1000
Defaults
parameter
auto | 10 | 100 | 1000 |
10000 | max 100 | max
1000}
Platforms Supported
OmniSwitch 6250
Usage Guidelines
•
You can only configure one slot at a time. Repeat the command to configure additional slots.
•
The auto option sets the speed to auto-sensing.
•
Configuration changes made with the interfaces speed command on combo ports configured as either
forced fiber or preferred fiber will only be made on the SFP fiber ports and not to the copper RJ-45
ports. See the interfaces hybrid speed
•
Configuration changes made with the interfaces speed command on combo ports configured as either
forced copper or preferred copper will only be made on the copper RJ-45 ports and not to the SFP fiber
port. See the interfaces hybrid speed
OmniSwitch 6250 CLI Reference Guide
Slot number you want to configure.
Port number of the interface you want to configure.
Last port number in a range of ports you want to configure.
The switch will automatically set the line speed to match the attached
device (auto-sensing).
Sets the interface to 10 Mbps.
Sets the interface to 100 Mbps.
Sets the interface to 1 Gigabit.
Sets the interface to 10 Gigabit.
Sets the maximum speed to 100 megabits.
Sets the maximum speed to 1000 megabits (1 Gigabit).
default
Auto (copper ports);
1000 (fiber ports);
command for more information.
command for more information.
November 2009 page 20-5