Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual page 729

Ethernet Port Commands
Examples
The following is an example for a non-combo port:
-> show interfaces 1/2 status
Slot/ AutoNego
Port (Mbps)
-----+--------+------+------+------+--------+------+------+------
1/2 Enable
The following is an example for a combo port:
-> show interfaces 1/25 status
Slot/ AutoNego
Port (Mbps)
-----+--------+------+------+------+--------+------+------+------
1/25 Enable
1/25 Enable
FF - ForcedFiber PF - PreferredFiber
FC - ForcedCopper PC - PreferredCopper C - Copper
output definitions
Slot/Port
AutoNego
Detected Speed
Detected Duplex
Detected Hybrid Type
Configured Speed
Configured Duplex
Configured Hybrid Mode
Trap Link Up/Down
Release History
Release 6.6.1; command was introduced.
OmniSwitch 6250 CLI Reference Guide
DETECTED
Speed Duplex Hybrid
Type
1000 Full NA
DETECTED
Speed Duplex Hybrid
Type
- - -
- - -
Interface slot/port number.
Autonegotiation status (Enable/Disable).
Detected line speed (10/100/Auto/1000/10000 Mbps).
Detected line duplex (Half duplex/Full duplex/Auto).
The detected combo port type, which can be F (fiber) or C (copper).
Configured line speed (10/100/Auto/1000/10000 Mbps).
Configured line duplex (Half duplex/Full duplex/Auto).
The configured combo port type, which is PF (Preferred Fiber). Con-
figuring the Hybrid Mode is not supported.
Trap Link status (up/down).
November 2009
CONFIGURED
Speed Duplex Hybrid
(Mbps) Mode
Auto Auto NA
CONFIGURED
Speed Duplex Hybrid
(Mbps) Mode
1000 Full PF
100 Auto PF
F - Fiber
Trap
LinkUpDown
-
Trap
LinkUpDown
Enable
Enable
page 20-57