GVRP Commands
gvrp port
Enables GVRP on a specific port or an aggregate of ports on the switch.
gvrp {linkagg agg_num | port slot/port}
no gvrp {linkagg agg_num | port slot/port}
Syntax Definitions
slot/port
agg_num
Defaults
By default, GVRP is disabled on the ports.
Platforms Supported
OmniSwitch 6250
Usage Guidelines
•
Use the no form of this command to disable GVRP on the specified ports.
•
GVRP can be enabled on ports regardless of whether it is globally enabled or
port to become an active participant, you should enable GVRP globally on the switch.
•
When GVRP is globally enabled on the switch and is not enabled on the port, that port is excluded
from the GVRP process.
•
GVRP can be enabled only on fixed ports, 802.1 Q ports, and aggregate ports. Other ports (mirror
ports, aggregable ports, mobile ports, and MSTI Trunking ports) do not support GVRP.
•
To use the agg_num parameter, the link aggregate group should be created and enabled.
Examples
-> gvrp port 3/2
-> no gvrp port 3/2
-> gvrp linkagg 2
Release History
Release 6.6.1; command was introduced.
OmniSwitch 6250 CLI Reference Guide
The slot number for the module and the physical port number on that
module (e.g., 3/1 specifies port 1 on slot 3).
The number corresponding to the aggregate group.
November 2009
not.
However, for the
page 23-3