Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual page 432

output definitions (continued)
AMAP Discovery Phase Time-
out Interval (seconds)
Remote Host Description
Remote Host Base MAC
Local Interface
Remote Interface
Remote IP Address
Configured
Release History
Release 6.6.1; command was introduced.
Related Commands
amap
amap discovery time
amap common time
page 14-8
The number of seconds to wait between each Hello packet transmission
during the discovery phase. Use the
change this value.
The system name for the adjacent switch.
The chassis base MAC address for the adjacent switch.
The local switch port/VLAN that received the AMAP packet.
The adjacent switch port/VLAN that sent the AMAP packet.
The number of IP addresses configured on the adjacent switch. The
actual IP address values are listed below this field.
Enables (default) or disables AMAP on a switch.
Sets the discovery transmission time interval used by active Span-
ning Tree ports in the discovery transmission state.
Sets the common transmission time interval used by the active
Spanning Tree ports in the common transmission state.
OmniSwitch 6250 CLI Reference Guide
Interswitch Protocol Commands
amap discovery time command to
November 2009