Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual page 805

VLAN Management Commands
•
When STP is disabled on a VLAN, it remains disabled even if the switch Spanning Tree operating
mode is set to 1x1 (one STP instance per VLAN). In addition, all active ports for the disabled VLAN
remain in a forwarding state in both the 1x1 and flat Spanning Tree modes.
•
If a switch is running in the flat Spanning Tree mode, disabling Spanning Tree on VLAN 1 disables the
instance across all VLANs. Disabling STP on any other VLAN disables the instance only for that
VLAN.
Examples
-> vlan 850 stp enable
-> vlan 720 stp disable
-> vlan 500 1x1 stp disable
-> vlan 500 flat stp enable
-> vlan 100-110 stp disable
-> vlan 500-510 600 720-725 stp enable
-> vlan 250 350 400-410 stp 1x1 enable
-> vlan 10 20 stp flat disable
Release History
Release 6.6.1; command was introduced.
Related Commands
vlan
bridge mode
show vlan
show vlan port
MIB Objects
vlanTable
vlanNumber
vlanStpStatus
vlan1x1StpStatus
vlanflatStpStatus
OmniSwitch 6250 CLI Reference Guide
Creates a VLAN.
Selects a flat Spanning Tree or 1x1 Spanning Tree operating mode for a
switch.
Displays a list of existing VLANs.
Displays VLAN port assignments.
November 2009 page 22-5