Telnet6 - Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual

telnet6

Invokes a Telnetv6 session. A Telnetv6 session is used to connect to a remote system or device over an
IPv6 network.
telnet6 {ipv6_address | hostname} [if_name]
Syntax Definitions
ipv6_address
hostname
if_name
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
•
To abort a Telnet session, enter CTRL + ] and then CTRL + D. Refer to your switch's User Manual
for more information on using Telnet.
•
If the session is invoked using the server's link-local address, the source interface name must be
provided.
•
You can establish up to 5 concurrent IPv4 or IPv6 telnet client sessions.
•
You can establish up to 4 concurrent IPv4 or IPv6 telnet sessions towards an OmniSwitch 6250 (i.e.
when the switch acts as a telnet server).
Examples
-> telnet6 fe80::a00:20ff:fea8:8961 intf1
-> telnet6 ::1
-> telnet6 Sun.com
Release History
Release 6.6.1; command was introduced.
page 6-40
Specifies the IPv6 address for the Telnetv6 server.
Specifies the hostname for the Telnetv6 server.
The name of the interface used to reach the Telnetv6 server, if the target
has been specified using the link-local address.
OmniSwitch 6250 CLI Reference Guide
Session Management Commands
November 2009