UDLD Commands
udld mode
Configures the operational mode of UDLD on a specific port, a range of ports, or all the ports.
udld port [slot/port[-port2]] mode {normal | aggressive}
Syntax Definitions
slot/port
port2
normal
aggressive
Defaults
parameter
normal | aggressive
Platforms Supported
OmniSwitch 6250-Metro Models
Usage Guidelines
•
The UDLD protocol must be enabled before using this command.
•
The UDLD protocol is not supported on aggregate ports.
•
When two UDLD enabled ports that are configured in aggressive mode of operation gets the link-up
asynchonously, then the UDLD port which gets the link-up indication first is considered to be in the
shutdown state. In such case, the link should be configured manually after both the links are up to start
UDLD detection.
•
In case of faulty cable connection, the port which is configured in normal mode of operation is deter-
mined to be in the shutdown state.
Examples
-> udld mode aggressive
-> udld mode normal
-> udld port 1/3 mode aggressive
-> udld port 2/4 mode normal
-> udld port 2/9-18 mode aggressive
Release History
Release 6.6.1; command was introduced.
OmniSwitch 6250 CLI Reference Guide
The slot number for the module and the physical port number on that
module (e.g., 3/1 specifies port 1 on slot 3).
The last port number in a range of ports that you want to configure on
the same slot (e.g, 3/1-4 specifies ports 1-4 on slot 3).
Specifies UDLD operation in the normal mode.
Specifies UDLD operation in the aggressive mode.
default
normal
November 2009
page 27-5