VLAN Stacking Commands
•
Note that if the peer switch connected to the VLAN Stacking network port supports the Provider MAC
address (i.e., STP, 802.1ad/D6.0 MAC), then enabling legacy BPDU support is not required on the
network port. Refer to the following table to determine the type of STP or GVRP MAC used:
STP
Customer MAC
Provider MAC address (802.1ad/D6.0)
Provider MAC address (Legacy MAC)
GVRP
Customer MAC address
Provider MAC address
•
GVRP legacy BPDU are supported only on network ports that already have GVRP enabled for the
port.
•
STP legacy BPDU are supported only when the flat Spanning Tree mode is active on the switch.
Examples
-> ethernet-service vlan 10 nni 1/3
-> ethernet-service vlan 255 nni 2/10-15 tpid 88a8
-> ethernet-service vlan 500 nni 31 stp legacy-bpdu enable
-> ethernet-service vlan 1500 nni 10 gvrp legacy-bpdu enable
-> no ethernet-service vlan 10 nni 1/3
-> no ethernet-service vlan 255 nni 2/12
Release History
Release 6.6.1; command was introduced.
Related Commands
ethernet-service svlan nni
MIB Objects
alaEServicePortTable
alaEServicePortID
alaEServicePortType
alaEServicePortVendorTpid
alaEServicePortLegacyStpBpdu
alaEServicePortLegacyGvrpBpdu
alaEServicePortRowStatus
OmniSwitch CLI Reference Guide
{0x01, 0x80, 0xc2, 0x00, 0x00, 0x00}
{0x01, 0x80, 0xc2, 0x00, 0x00, 0x08}
{0x01, 0x80, 0xc2, 0x00, 0x00, 0x00}
{0x01, 0x80, 0xc2, 0x00, 0x00, 0x21}
{0x01, 0x80, 0xc2, 0x00, 0x00, 0x0D}
Configures the switch port as a VLAN Stacking NNI and associates the
port with a customer SVLAN, management SVLAN, or an IP Multicast
VLAN (IPMV).
November 2009
page 24-11