Interfaces Crossover - Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual

Hide thumbs Also See for OmniSwitch 6250:

Table of Contents

Ethernet Port Commands

interfaces crossover

Configures port crossover settings on a single port, a range of ports, or an entire Network Interface (NI).

interfaces slot[/port[-port2]] crossover {auto | mdix | mdi}

Syntax Definitions

auto | mdix | mdi

(all copper ports)

Platforms Supported

OmniSwitch 6250

Usage Guidelines

You can only configure one slot at a time. Repeat the command to configure additional slots.

If auto negotiation is disabled, then automatic crossover will also be disabled. See the

You cannot configure crossover settings on fiber ports. These ports use the MDI standard.

Configuration changes made with the interfaces crossover command on combo ports configured as

either forced copper or preferred copper will only be made on the copper RJ-45 ports and not to the

SFP fiber port. See the

-> interfaces 3 crossover mdi

-> interfaces 3/1 crossover mdix

-> interfaces 3/1-4 crossover auto

Release History

Release 6.6.1; command was introduced.

OmniSwitch 6250 CLI Reference Guide

Slot number you want to configure.

Port number of the interface you want to configure.

Last port number in a range of ports you want to configure.

The interface will automatically detect crossover settings.

Sets the crossover configuration to Media Dependent Interface with

Crossover (MDIX), which is the standard for hubs and switches.

Sets the crossover configuration to Media Dependent Interface (MDI),

which is the standard for end stations.

for more information.

interfaces hybrid crossover

November 2009

command for more information.