Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual page 578

output definitions (continued)
Path Cost
Desig Cost
Role
Prim. Port
Op Cnx
Op Edg
Desig Bridge ID
-> show spantree msti 1 ports configured
Spanning Tree Port Admin Configuration
Port Adm Man. Config
Port Pri St. Mode
-----+----+----+----+-------+----+----+----+----+----+--------
1/1 7 ENA
1/2 7 ENA
1/3 7 ENA
1/4 7 ENA
1/5 7 ENA
1/6 7 ENA
1/7 7 ENA
1/8 7 ENA
1/9 7 ENA
1/10 7 ENA
1/11 7 ENA
1/12 7 ENA
output definitions
Port
Port Pri
Adm St
page 16-138
The contribution of this port to the path cost towards the Spanning Tree
root bridge that includes this port. Path cost is a measure of the distance
of the listed port from the root bridge in the number of hops. Config-
ured through the
The path cost of the Designated Port of the segment connected to this
port. If this is the root bridge or the Spanning Tree status of the port is
administratively disabled, this value is 0.
The role of the port for this Spanning Tree instance. Possible port roles
are: root, designated, alternate, and backup.
The slot number for the module and the physical port number on that
module for the primary port associated with this Spanning Tree
instance. This information is only available if the port role is backup.
Operational connection type: PTP, NPT, or NS (nonsignificant).
Shows the current operational state of the port's connection type. See
the bridge slot/port connection
information.
Operational connection type: EDG. Shows the current operational state
of the port's connection type. See the
command on
The bridge identifier for the designated bridge for this port's segment.
Adm Adm
Cost Cnx Edg
No 0 AUT No
No 0 AUT No
No 0 AUT No
No 0 AUT No
No 0 AUT No
No 0 AUT No
No 0 AUT No
No 0 AUT No
No 0 AUT No
No 0 AUT No
No 0 AUT No
No 0 AUT No
The slot number for the module and the physical port number or a logi-
cal port. If the slot number is 0, then the port number refers to a link
aggregate logical port number (e.g., 0/31).
The Spanning Tree priority for the port (0–15). The lower the number,
the higher the priority. Configured through the
ity command.
The Spanning Tree administrative status of the port: enabled or dis-
abled. Configured through the
disable Spanning Tree on a port.
Distributed Spanning Tree Commands
bridge slot/port path cost
command on
bridge slot/port connection
page 16-87 for more information.
Aut Rstr Rstr OS8800
Edg Tcn Role 10G Opt.
Yes No No DIS
Yes No No DIS
Yes No No DIS
Yes No No DIS
Yes No No DIS
Yes No No DIS
Yes No No DIS
Yes No No DIS
Yes No No DIS
Yes No No DIS
Yes No No DIS
Yes No No DIS
bridge slot/port
OmniSwitch 6250 CLI Reference Guide
command.
page 16-87 for more
bridge slot/port prior-
command to enable or
November 2009