Show Interfaces Hybrid Flow Control - Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual

Hide thumbs Also See for OmniSwitch 6250:

Table of Contents

Ethernet Port Commands

show interfaces hybrid flow control

Displays interface flow control wait time settings for combo ports.

show interfaces [slot[/port[-port2]]] hybrid {fiber |copper} flow control

Syntax Definitions

If a specific slot or slot/port number is not entered with this command, the flow control wait tme settings

for all switch combo ports is displayed..

Platforms Supported

OmniSwitch 6250

Usage Guidelines

Use the slot, slot/port, or slot/port-port2 parameters to display the flow control wait time settings for all

ports on a slot, a specific port, or for a range of ports.

-> show interfaces hybrid fiber flow control

-----------+--------+---------------+--------+-----------

output definitions

OmniSwitch 6250 CLI Reference Guide

Slot number you want to display.

Port number of the interface you want to display.

Last port number in a range of ports you want to display.

Specifies that the configuration of the SFP port(s) will be displayed.

Specifies that the configuration of the copper RJ-45 port(s) will be

Wait time(usec) Cfg-Flow

Interface slot and port number

Interface status.

Flow control wait time, in microseconds.

Flow control status, which can be Pause or Go.

The user-configured cross-over setting, which can be Auto, MDI, or

November 2009