Show Configuration Status - Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual

show configuration status

Displays whether there is a pending timer session scheduled for a configuration file and indicates whether
the running configuration and the saved configuration files are identical or different. This command also
displays the number of error files that will be held in the flash directory.
show configuration status
Syntax Definitions
N/A
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
•
A timer session can be scheduled using the
refer to page 9-2.
•
The screen output File configuration </path/filename>: scheduled at dd/mm hh:mm indicates that a
timer session has been scheduled for a later time.
•
The output No file configuration has been scheduled indicates an idle timer session (i.e., no timer
session has been scheduled for a configuration file).
•
The output File configuration is in progress indicates that a file is currently being applied to the
switch.
•
The output File configuration </path/filename>: completed with 2 errors indicates that the named
file was applied to the switch with two recorded errors.
•
When the running and saved configurations are the same, the output Running configuration and
saved configuration are identical will be displayed.
•
When the running and saved configurations are the different, the output Running configuration and
saved configuration are different will be displayed.
•
To synchronize the running and saved configuration, use the
Examples
-> show configuration status
Release History
Release 6.6.1; command was introduced.
page 9-6
Configuration File Manager Commands
configuration apply command. For more information,
write memory
OmniSwitch 6250 CLI Reference Guide
command.
November 2009