Interfaces Duplex - Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual

Hide thumbs Also See for OmniSwitch 6250:

Table of Contents

Ethernet Port Commands

interfaces duplex

Configures duplex mode. In full duplex mode, the interface transmits and receives data simultaneously. In

half duplex mode, the interface can transmit or receive data at a given time. Auto duplex setting causes the

switch to advertise all available duplex modes (half/full/both) for the port during autonegotiation.

interfaces slot[/port[-port2]] duplex {full | half | auto}

Syntax Definitions

full | half | auto

Platforms Supported

OmniSwitch 6250

Usage Guidelines

You can only configure one slot at a time. Repeat the command to configure additional slots.

Half duplex mode is not supported on Gigabit modules if a port is detected as Gigabit (1000 Mbps).

Configuration changes made with the interfaces duplex command on combo ports configured as either

forced copper or preferred copper will only be made on the copper RJ-45 ports and not to the SFP fiber

port. See the

interfaces hybrid duplex

OmniSwitch 6250 CLI Reference Guide

Slot number you want to configure.

Port number of the interface you want to configure.

Last port number in a range of ports you want to configure.

Sets interface to full duplex mode.

Sets interface to half duplex mode.

Switch will automatically set both the duplex mode settings to auto-

negotiation.

command for more information.

November 2009